Omegaprofile

Ideal for:

• Standing walls and lightweight walls
• Horizontal & [Overhead mounting
• Free panel installation in a grid

Advantages at a glance:

• No base profile required: Direct mounting on horizontal mounting rails
• Flexible profile positioning: Independent of the stand spacing – more planning freedomv
• Tool-free panel mounting: Simple mounting ävia retaining grooves
• Safe & quiet: Pressure spring prevents rattling, protects against wind load
• Anti-lift device: additional protection against unintentional lowering of the plates

[nbsp]]

Typical areas of application:

• Lightweight walls, drywall, sandwich panels
• Ideal for pre-hung, rear-ventilated facades
• Horizontal, bonded, overhead

Notes on installation

The substructure must be installed in accordance with project-specific structural calculations. The general building authority approval Z-10.3-844 serves as the basis.

• The profiles of the basic substructure must be installed perpendicular and flush (hat or alternatively Z-profile).
• The Omega profiles K20 (art. no. 624, 627, 633) must be aligned exactly horizontally and fastened with screws (art. no. 659) or rivets (art. no. 658) through the pre-punched slots at the edge (note the fixed and sliding point formation!).
• The distance between the rails in the horizontal direction must correspond to the length grid of the panels.
• The length of the vertical profiles must be divisible by the height of the panels and should not exceed the height of one storey.
• The profile joint must not lie behind a panel.
• With open vertical joints, one spacer (Art. No. 645) per panel is inserted into a centered drawing hole in the panel.
• For closed vertical joints, the joint profile (Art. No. 640 for single panel – Plug-in joint profile Art. No. 647 for single panel support with cantilever arms) must be used.

[nbsp]]

Delivery lengths Profiles:
Raster 15 cm, 60 cm: 2992 mm
Raster 17.5 cm: 2967 mm · Raster 20 cm, 25 cm, 30 cm, 37.5 cm, 50 cm: 2992 mm
Raster 22.5 cm, 32.5 cm: 2917 mm · Grid 27.5 cm: 3017 mm
Grid 35 cm, 40 cm: 2792 mm · Grid 55 cm: 3292 mm
Grid 45 cm: 2692 mm

Omegaprofile K20 available for panel grids:
15 cm - 17.5 cm - 20 cm - 22.5 cm - 25 cm - 27.5 cm - 30 cm - 32.5 cm - 35 cm - 37.5 cm - 40 cm - 45 cm - 50 cm - 55 cm - 60 cm. Other grids on request.

Please note: The use of silicone rubbers should generally be avoided, as silicone oils migrate and create sticky, dirt-binding surfaces. Therefore, please only use the system components mentioned (foam punched parts, EDPM rubber, neoprene washer) or jointing, adhesive and sealing materials recommended by us, which we will be happy to provide you with up-to-date information on. The üusual final building cleaning is still necessary. A warranty for the KeraTwin^® K20 system within the scope of the general building inspectorate approval no. Z-10.3-844 only applies when the system components shown on these pages are used.